![]() ![]() You should occasionally train non-junk messages - doing it when you mark bad messages as junk is a good habit.If it is not, see the tweaking information below. You should find that Junk Mail Controls are effectively detecting unwanted junk emails and keeping them from your Inbox.It's best to mark different types of messages good and bad - marking 500 messages from the same source is not as good as marking 500 messages from different people.If you mark a thousand spam messages but do not mark legitimate messages, or very few, it won't work well.To work best, it needs a few hundred of each marked. Bayesian filtering requires at least 100 bad messages be marked as spam and 100 good messages marked as not junk to function.Check your Junk folder to see if any non-junk messages have been detected as junk, and mark non-junk ones as not junk.Initially, incoming messages might not be accurately junked because you have not trained it enough. It is important to mark both types of messages, both good and bad, not just the ones that are junk. Training involves marking many messages as "junk" and many messages as "not junk". Junk processing must be well trained for it to work correctly. See this link for the menu paths for operating systems other than Windows. ![]() When finished with account settings, click the "OK" button.If you have more than one email account, repeat the above steps for each account with which you want to use the Junk Mail Controls.But if you do not enable it, then you must periodically Empty Junk. (Junk folder normally will not appear alongside your other mail folders until you mark your first message as Junk.) Make sure that the checkbox for "Move junk messages to" is checked, unless you want junk mail kept in your Inbox.However, message filters may be used to test whether the sender "contains" a domain, and set the junk status accordingly, because filters are run before the junk mail controls. It only supports whitelisting specific email addresses, and only those in your address books.Choose your settings for Whitelists at "Do not mark mail as junk.".Make sure that the checkbox for "Enable adaptive junk mail" is checked.(This is different from the message filters, where you select the account that retrieves the email.) So if you use the Global Inbox for a pop account, you must select "Local Folders" as the account. "Email account" means the folder structure under which the emails are saved. In Account Settings, choose the email account for which you want to activate the Junk Mail Controls.There is only one set of training data, so don't reset it thinking it will only affect one account. Caution: "Reset Training Data" applies to ALL of your accounts.Click Tools -> Options -> Security -> Junk.Note: Controls are divided between two locations: (a) Tools -> Options -> Security -> Junk, and (b) Tools -> Account Settings -> *each account* -> Junk Settings.To start using the Junk Mail Controls in Thunderbird *: 17.2 Add-ons interfacing to external services.17.1 Add-on to improve Thunderbird's junk processing.12 Check the spam score of messages you sent.5 Use custom headers added by your email provider. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |